Publicité
STORAGE
CAUTION: Never place any type of storage cover or tarp on the MOWER while it is still hot.
If the MOWER is being stored for extended periods of time (30 days or more), drain fuel tank and
carburetor bowl.
When storing the mower for extended periods of time:
1. Start the engine and run it until the tank, carburetor bowl and fuel line are completely empty and
the engine stalls.
2. Change the oil after each season.
3. Remove the spark plug. Use an oil-can to fill the cylinder with approx. 2 ml of oil. Slowly pull
back the starter handle, which will bathe the cylinder wall with oil. Screw the spark plug back in.
4. Clean the cooling fins of the cylinder and the housing.
5. Be sure to clean the entire equipment to protect the paint.
6. Store the equipment in a well-ventilated place.
NOTE: LIMITED WARRANTY does not cover fuel system damage or engine performance
problems resulting from neglected storage preparation.
TROUBLESHOOTING
Problem
Engine fails to start
Engine runs erratic.
Engine overheats.
Idles poorly.
Excessive
vibration/noise
Mower will not mulch
grass.
Uneven cut.
All manuals and user guides at all-guidesbox.com
Cause
Engine start/stop lever
disengaged.
Spark plug wire
disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
Faulty spark plug.
Blocked fuel line.
Engine flooded.
Spark plug wire loose.
Blocked fuel line or stale fuel.
Water or dirt in fuel system.
Dirty air filter
Engine oil level low.
Air flow restricted.
Spark plug fouled, faulty, or
gap too wide.
Dirty air cleaner.
Blade loose or unbalanced.
Bent/damaged blade.
Wet grass.
Excessively high grass.
Dull blade.
20
Solution
Engage engine start/stop lever.
Connect spark plug wire.
Fill tank with clean, fresh gasoline.
Press primer bulb.
Clean, adjust gap, or replace.
Clean fuel line.
Wait a few minutes to restart, do not
prime.
Connect and tighten spark plug wire.
Clean fuel line. Fill tank with clean, fresh
gasoline. Drain carburetor bowl.
Drain fuel tank. Refill with fresh fuel.
Clean or replace.
Fill crankcase with proper oil.
Clean area around and on top of engine.
Reset gap or replace spark plug.
Clean or replace.
Tighten and balance blade.
Replace the blade.
Do not mow when grass is wet, wait until
dry to cut.
Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting path.
Sharpen or replace blade.
Publicité
