Publicité
Maintenance
4. Loosen the left and right adjuster knobs (1) (see
Figure 14). Push down on each side of the mower
housing. Make sure both sides of the mower
housing are setting on a flat surface. Also, make
sure the lift links are loose and can easily move up
or down.
5. Push down on the lift links (2) and tighten the left
and right adjuster knobs. Make sure the adjuster
knobs are tight. If necessary, use a wrench to
tighten the adjuster knobs.
6. Raise the lift lever (1) (see Figure 13).
7. Mow for a short distance. If the height of cut is not
level, repeat the above steps.
1
2
20
All manuals and user guides at all-guidesbox.com
Where to Lubricate
NOTE: Apply grease to the steering gear assembly.
CAUTION: If the unit is operated in dry areas that have
sand, use a dry graphite spray to lubricate the unit.
Figure 13
2
1
Check the Tires
Check the air pressure in the tires. Tires with too much
air pressure will cause the unit to ride rough. Also, the
Figure 14
wrong air pressure will keep the mower housing from
cutting level. The correct air pressure is: Front Tires
0,97 BAR (14 PSI), Rear Tires 0,69 BAR (10 PSI).
Models with grease fittings: Lubricate with
grease gun (see Figure 15).
Apply grease with a brush to the areas
shown.
Lubricate the areas shown with engine oil.
en
Figure 15
Publicité
