Federal Communications Commission
Pursuant to part 15.21 of the FCC Rules, you
are cautioned that changes or modifications not
expressly approved by the party responsible for
compliance could void your authority to operate the
product.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
SPECIFICATIONS
Charger Cat. No. ................................ 48-59-1201
Input....................................................5 VDC, 2.1 A
Output .........................................................12 VDC
USB Output ........................................9 VDC, 1.6 A
Recommended Ambient Charging
Temperature .............40°F to 104°F (5°C to 40°C)
Power Supply Cat. No*. ........................44-66-1202
Wall Plug Input Volts ....................................120 AC
M12™ Li-Ion Battery Packs ........................ 12 V DC
*Wall Plug and Micro-USB Cable available sepa-
rately. Included with some kits.
SYMBOLOGY
Volts
Direct Current
Amps
BFP
Backfeed Protected
Properly Recycle Batteries
Read Operator's Manual
UL Listing for Canada and U.S.
1. USB A port (output)
2. Power cable port (output)
3. Charging indicator LEDs
4. Micro-USB port (input)
5. USB power button
6. Fuel gauge
7. Contacts
8. Release buttons
9. Micro-USB Cable
10. Micro-USB
11. USB A
12. Wall plug prongs
13. Wall plug USB A port (output)
5 VDC, 2.1 A
Compared to NiCd battery pack types, MILWAUKEE
Li-Ion battery packs deliver fade-free power for their
entire run time. The tool will not experience a slow,
gradual loss of power during use.
The regulations pertaining to the transport of Li-ion
batteries are affected by whether the battery is trans-
ported in a personal vehicle or offered for shipment
via a commercial carrier. Always ship Li-Ion batteries
in accordance with the current regulations governing
the chosen mode of transport (e.g. ground, air, sea).
When in doubt, contact MILWAUKEE, the carrier
or other trained Dangerous Goods professional to
determine applicable regulations.
The personal transport of Li-Ion battery packs is al-
lowed when done in accordance with these warnings
and instructions. When shipping Li-ion batteries with
a commercial carrier, they are shipped under classifi-
cation UN 3480 (battery only) or UN 3481 (batteries
contained in or packed with equipment). The proper
packaging, labeling, marking, and documentation
requirements are generally dependent upon whether
the particular batteries are rated greater than or less
than 100 Wh. Often, Li-Ion batteries rated 100 Wh or
less are "excepted" from certain shipping regulations.
In the U.S., products shipped via ground transport
may be "excepted" from certain hazardous material
shipping regulations if they are under 300Wh.
3
FUNCTIONAL
DESCRIPTION
2
6
1
BATTERY
OPERATION
Transport
3
4
5
7
10
8
9
12
11
13