Geberit Preda Manuel D'entretien page 28

EN
Replacing the control electronics
→ See figure sequence
1
Demount the urinal flush control.
2
Disconnect the cables for the power supply
and the solenoid valve.
3
Remove the defective control electronics.
4
If required, install the Geberit App and make
a note of the pairing secret for the new
control electronics.
5
Insert the new control electronics.
6
Connect the cables for the solenoid valve
and the power supply.
7
Mount the urinal flush control.
28
1 , page 615.
8
Use the Geberit App or Geberit Service
Handy to make the desired settings or apply
saved presettings.
Result
✓ The urinal is ready for operation.
Replacing the solenoid valve
→ See figure sequence 2
1
Demount the urinal flush control.
2
Disconnect the solenoid valve cable.
3
Demount the coupling and solenoid valve.
4
Prepare the new solenoid valve.
5
Mount the new solenoid valve and coupling.
6
Connect the cable for the solenoid valve.
7
Mount the urinal flush control.
Result
✓ The urinal is ready for operation.
, page 618.
90071995661314699 © 11-2022
970.650.00.0(02)