Axis Q1961-XTE Guide D'installation page 7

AXIS Q1961-XTE Explosion-Protected Thermal
• Modifications or design changes to the device are not allowed.
• Safety rules and national regulations must be observed.
• Never install the device in an area that may exceed the ambient temperature range.
• Aggressive substances may require extra protection.
• The device must be protected by additional means of protection if it is exposed to
excessive external stress, that is vibration, heat or impact.
• If the device is not used in a manner specified by the manufacturer, the device's
protection may be impaired. Incoming cables must comply with the national standards.
• If the device is re-installed or the incoming cables are re-wired, new grommets must be
used. The rubber of the grommet must be fresh and the grommet must be unused.
• Replacement parts may only be installed using component parts as specified by Axis
Ex AB.
• Fixing brackets must be tightened upon installation. Suitable screws must be used. See
the device's datasheet for information about the weight.
• Install in an appropriate environment, according to IEC/EN/UL 60079-14 and
IEC/EN/UL 60079-17.
• The power connector must be glued when connected. Apply glue on the male connector.
Manufacturer
Gorilla Glue
Henkel
Permabond
Permabond
Permabond
Cable gland
To fulfil JPEx certification, this device must be installed with the specified cable gland, included
with the unit.
Manufacturer
Thread type
Model name
Ex marking
IECEx certificate number
Camera (防 防 防 爆 爆 爆 サ サ サ ー ー ー マ マ マ ル ル ル カ カ カ メ メ メ ラ ラ ラ )
Glue type
Gorilla Super Glue
LOCTITE 402
Permabond 801
Permabond 802
Permabond 820
Jacob GmbH
M20x1.5
K100-1020-00-EX
Ex eb IIC GbEx tb IIIC Db
IECEx BVS 17.0101X
7
Temperature range of
adhesive
-55°C to +100°C
-40°C to +135°C
-55°C to +130°C
-55°C to +160°C
-55°C to +200°C
EN