Table des Matières
Publicité
The CR123 battery must be inserted in the correct battery compartment orientation (+/- polarity)
•
If the indicator light flashes red and green and the alarm sounds briefly, the battery must be
replaced immediately.
•
Lift the cover using a suitable screwdriver as shown above (Fig. 6).
•
Gently remove the used battery.
•
Replace it with a new battery of exactly the same type (3V CR 123 lithium battery)
•
The battery must be inserted in the correct orientation (+/- polarity)
•
Replace the cover on the bulb .
•
Press the test button located by the green indicator light for 2 seconds (as shown in Fig. 4).
•
The light will turn red and an audible signal will sound twice per second three consecutive
times confirming that the electrical circuit has been made and that the alarm and the battery
are in correct working order. This signal indicates that the smoke detector has been correctly
initialised. The light should return to green after the test.
•
The smoke detector and alarm is now active.
•
Only replace the battery with a brand new one. The battery terminals must never be short-
circuited. This should only be done by an adult.
5.4 Test the detector once a month
•
Press the test button located by the green indicator light for 2 seconds (as shown in Fig. 4).
•
The light will turn red and audible signals will sound twice per second three consecutive
times confirming that the electrical circuit has been made and that the alarm and the battery
are in correct working order. This signal indicates that the smoke detector has been correctly
initialised. The light should return to green after the test.
•
The smoke detector and alarm is now active.
•
If the indicator light starts flashing red and green and an audible signal sounds briefly (once
per second), this is warning you that the battery must be immediately replaced as shown in
Section Inserting and Replacing the Battery
•
If the indicator light flashes red and green and the alarm sounds briefly (twice per second),
this is warning you that the smoke detector is defective. You should then contact the Bell &
Wyson customer care department and replace the defective detector while it is being
repaired, if necessary. In this event please see Section 9, Customer Care.
Publicité
Table des Matières
