Bell & Wyson BW 1.1 Wifi Manuel D'utilisation page 24

Fig 1
WARNING! Do not insert the bulb without first installing the smoke detector battery. Removing the
battery will render the smoke detector inoperable.
IMPORTANT! Read these instructions carefully before installation. Keep these instructions for the life
of the bulb for later reference.
CAUTION! The battery may explode or cause injury if disassembled, recharged or exposed to water,
flames or elevated temperatures. Keep out of the reach of children. If swallowed seek medical
attention urgently.
2) RECOMMENDED POSITIONS FOR THE BW 1.1
Installation
•
The BW 1.1 should be installed in a position which is suitable for a smoke detector.
•
When installed in a ceiling fixture make sure the BW 1.1 is at least 100 mm from walls (see
diagram below)
•
When wall-mounted, mount the BW 1.1 on a partition wall at least 100 mm and at most 305
mm from the ceiling.
•
Install two smoke detectors at either end of corridors and in large rooms which are over 9m
long.
•
The BW 1.1 must be installed with the detector opening facing the floor. May be wall-
mounted as long as the distances from the ceiling, wall and floor are respected (see diagram)