Publicité
Captions :
Intensive™ or FLOWMAX pump (B + C)
A
B
Air motor
C
Fluid section
D
'MOTOR AIR' air regulator
E
Gauge
H
Air inlet valve
I
Ground
J
Relief valve
(For specific installation, please contact your SAMES KREMLIN representative).
Nota : If the pump is equipped with an accumulator filter (M), the filter is supplied with a screen n° 12
(filtration size : 280 µ or 55 mesh). The screen is recommended for the use of an AIRLESS gun fitted with
a nozzle model 20. If the fluid spraying is carried out by means of an other nozzle, please choose an other
screen (refer to filter instruction manual).Adjust the screen to the application.
Guards (air motor cover, coupling shields, housings ...) have been designed for safe use
The manufacturer will not be held responsible for bodily injury or failure and / or damage
to property due to removal or partial removal of the guards
Start up procedure :
1 -
Ground the pump.
2 -
If the pump is a intensive™ one, fill up the wetting-cup (S) with "T" lubricant (R) or with
an appropriate solvent.
3 -
Unscrew the air regulator (D).
4 -
Interconnect the equipment with the air pressure network (clean air - P< 6 bar / 87 psi). Install a
water drop, model 3/4" if it is necessary.
5 -
Connect all the hoses , compressed air general supply hose and fluid hose (P), as well as the
gun (Q).
Nota : Comply with the diameters of hoses recommended in the specifications of the pump.
6 -
Remove the nozzle from the gun.
FLUSHING WITH SOLVENT
7 -
Immerse suction rod (L) and air shut off rod (O) into the material container.
8 -
Open air shut off valve (N).
9 -
Open the valve (H) of the pump air equipment to supply the air motor.
Nota : If the air motor is a 5000 or a 8000 version, it needs pilot air to operate. The pump air
equipment supplies pilot air to the air motor. The air supply pressure is adjusted previously in the
factory to 4 bar / 58 psi maximum.
10 - Increase the air regulator (D) so that the pump runs slowly (Pressure between 0.5 and 1 bar
/ 7.25 to 14.503 psi).
11 - Observe the drain (O); air bubbles come out from it. When bubbles no longer come out from it,
shut off the drain valve (N).
SAMES KREMLIN
L
Suction rod (depending on version)
M
Accumulator filter (depending on version)
N
Air shut off valve (depending on version)
O
Air shut off rod (depending on version)
P
HP Fluid hose
Q
Gun
R
T lubricant (125 ml / 4.4 oz)
(only for intensive™ pump)
S
Wetting-cup
(only for intensive™ pump)
of the equipment.
- 3 -
N° : 578.029.120-UK-1810
Publicité
