Publicité
PUMP
Make sure that the pump is clean and in good condition to increase equipment working life.
If the pump is a intensive™ one :
- Make sure the pump fluid outlet flange is always filled up with T lubricant (this T lubricant will
normally be coloured by the paint).
- Regularly clean the wetting-cup with solvent after having drained the lubricant (Unscrew the plug
placed at the upper flange).
Guards (motor cover, coupling shields, connectors,...) have been designed for a
The manufacturer will not be held responsible for bodily injury or failure and / or
property damage due to destruction, the overshadowing or the partial or total
Make sure that the suction strainer is clean and in good condition. Clean it regularly and replace it if it
is necessary.
Flush the pump as often as necessary, specially when spraying pigment filled-material.
Whatever the case, when stopping the pump, always leave it filled with material :
For a short duration shutdown, if the flushing has not been carried out, leave the pump
filled with material.
For a long duration shutdown, after flushing, leave it filled with solvent.
SPRAY GUN
Comply with the usual instructions of spray gun servicing (refer to spray gun manual).
FILTER
If the pump is equipped with a filter at the fluid outlet, comply with the usual instructions of filter
servicing (refer to filter manual).
SAMES KREMLIN
safe use of the equipment.
removal of the guards.
- 1 -
N° : 578.030.110-UK-1810
Publicité
