VOLTOMAT HEATING BAHAG 25391008 Mode D'emploi page 70

FH-111907.1 / FH-111907.2
PARTS DESCRIPTION
1. Thermostat control switch
2. Air outlet grille
3. Heat select switch
4. Indicator light
5. Swing function switch
Heat setting:
"0" position – OFF
– Ventilation
" I " – WARM AIR (low heat output)
" II "– WARM AIR (high heat output)
OPERATION
Rotate the switch to choose the suitable setting --- "

output)/ " II "– WARM AIR (high heat output).
Turn the thermostat control switch to the position "+". The indicator light illuminates when the

appliance is heating.
The thermostat will turn the heater off when the selected room heating is achieved, and when the

temperature drops it will turn on again automatically.
Make the heater oscillate or not by pressing the swing function switch at the back. The heater doesn't

oscillate when the switch is pressed at the position "O".
Note: To switch off the appliance, it is recommended to turn the heat switch to ventilation setting for about
15 seconds to cool down. After that, please turn the heat switch to "0" position and then unplug the
appliance. This can help prolong the lifespan of the appliance.
SAFETY SYSTEM
The appliance has a safety system which automatically switches off the unit when overheated, for

example, due to the total or partial obstruction of the vents. In this case, switch off the appliance,
remove the plug from the socket. Let it cool down for about 30 minutes and remove the object which is
obstructing the vents. Then put the plug in the socket and switch on the heater. It should now operate
normally.
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will

automatically switch off the power if it is put on unstable or uneven surfaces or if it is tilted
accidentally.
MAINTENANCE
The fan heater only needs regular cleaning on the outside.

Before you clean the unit, turn the switch off. Remove the plug form the socket and wait until the fan

heater cools down completely.
Use a damp cloth to wipe the heater housing.

Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the

appliance.
"– ventilation/ " I " – WARM AIR (low heat
- 69 -
GB