Publicité
Les langues disponibles
Les langues disponibles
Lighting
You can check whether the flue has sufficient draught
by lighting a ball of paper above the baffle plate. A cold
flue often has insufficient draught and consequently,
some smoke may escape into the room instead of up
the chimney. You can avoid this problem by lighting
the fire as described below.
1. Stack two layers of medium sized logs crosswise.
2. Stack two to three layers of kindling crosswise on
top of the logs.
3. Place a firelighter between the bottom layer of kind-
ling and light the firelighter according to the instruc-
tions on the packaging.
4. Close the appliance door and open the primary
and secondary air inlets; see the following figure.
5. Allow the fire develop into a good blaze until there
is a glowing bed of charcoal. You can then add fuel
and adjust the appliance, see the chapter "Stoking
with wood".
12
2
1
Maximum amount of wood
To stoke continuously at the rated power, wood must
be added every 45 minutes. If you use a smaller
amount of wood each time, you can add wood more
often. Each stove is designed to work with a specific
maximum amount of wood. If you use a larger quantity
of wood, the heat output increases. This can cause
the hearth to be overloaded and parts can be dam-
aged.
Allowable maximum amount of fuel when using wood
with a moisture content of 15%:
09-20500-016
TAI 35W 6.5 kW can be filled with a maximum of
1.4 kg of wood every 45 minutes.
Burning wood
After you have followed the instructions for lighting:
1. Slowly open the door of the appliance.
2. Spread the charcoal evenly across the bottom of
the stove base.
3. Stack a few logs on the charcoal.
= Open
o
l
Do not fill the combustion chamber more than
one third full, and never stack wood above the
openings for secondary air.
Subject to change because of technical improvements
09-20020-365
= Closed
Publicité
