Publicité
Les langues disponibles
Les langues disponibles
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill the fuel tank
WARNING: Obey the procedure that follows
for your safety.
1. Stop the engine and let the engine become cool.
1559 - 003 - 01.10.2020
2. Clean the area around the fuel tank cap.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
3. Shake the container and make sure that the fuel is
0.40
4. Remove the fuel tank cap slowly to release the
US fl. oz.
5. Fill the fuel tank.
2 ½
6 ½
12 ⅞
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
Note: To see where the fuel tank is on your product,
refer to
To start the engine
1. Push the air purge bulb again and again until fuel
fully mixed.
pressure.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
refueling area and fuel source before you start the
engine.
Introduction on page 2 .
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
9
Publicité
