Publicité
Les langues disponibles
Les langues disponibles
OPTIONAL REMOTE BULB CONTROL INSTALLATION
INSTRUCTIONS
Note:
At the option of the owner, the remote bulb control may be
located on the left or right side of the outer casing.
1.
Remove remote bulb control from the shipping carton.
2.
Remove outer casing assembly from shipping carton.
Note: If wall furnace is already installed, remove outer casing from
unit and lay on floor with front side down.
3.
Attach wire assembly to remote bulb control.
4.
Carefully unwind capillary wire on remote bulb control.
5.
Remove (3) hole plugs from left or right side of outer casing
where remote bulb control is to be installed.
6.
Mount remote bulb control to inside of outer casing with (2) No.
6-32 x 1/4" (6mm) screws.
Page 18
INSTRUCTIONS
MODELS
GWT-25 RB, GWT-35 RB, GWT-50 RB
Index
No.
1
2
3
4
5
6
7
quired)
Caution: Remote bulb wire routing is important. Wires should be in
7.
8.
9.
10. Use third plastic clip to secure wire assembly and capillary
11. Attach control knob to remote bulb control.
12. Install furnace according to instructions in the Installation In-
Note: If wall furnace is already installed, secure outer casing to
13. Attach wire assembly to gas valve at the "TH" and "TH/TP"
Part
Number
Description
GW-130
Remote Bulb Control Kit
R-1224
Remote Bulb Control
R-2499
Wire Assembly
R-1162
Control Knob
R-1720
Plastic Clip (3 Required)
R-1223
Instructions
R-1578
No. 6-32 x 1/4" (6mm) Screw (2 Re-
proper location to avoid damage from being overheated.
Incorrect routing of remote bulb control wires may result
in damage to wires and incorrect operation of remote
bulb control. Follow these instructions and refer to the
drawing for proper wire routing.
If remote bulb control is located on the right side of the outer
casing, carefully bend or loop capillary wire around control. This
will enable the sensing bulb to be positioned at the bottom of
the unit.
Secure sensing bulb on the inside, at the bottom, of the outer
casing with (2) plastics clips.
Feed the wire assembly down along the inside of the outer
casing.
wire to the casing. (Approximately 24" (610mm) from bottom
of unit.)
structions and Owner's Manual.
unit.
terminals on the Robertshaw valve.
Attach wire assembly to gas valve at the "THERMO" terminals
on the ITT valve. If the wire assembly has two 1/4" (6mm)
female connectors, the connectors should be cut off the wire
assembly. Strip and bare the wires and attach wires to the
"THERMO" terminals.
Note: This remote bulb control is connected to the gas valve
the same way as a wall thermostat. Any references made to
the thermostat in the lighting instructions would also apply to
the remote bulb control.
32038-1-0314
Publicité
