Télécharger Imprimer la page

Bartscher 2 x 1/2 GN Mode D'emploi page 23

Masquer les pouces Voir aussi pour 2 x 1/2 GN:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
5.2 Installation and connection
Discard the complete packing material after unpacking the device.
Place the device on top of an even and safe surface which supports the weight of
the device and is not heat sensitive.
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Operating
Clean the unit prior to first use (see 6.2 „Cleaning").
Fill the container to the „MAX" marking located on the inside.
CAUTION!
Ensure the water level does not drop below the „MIN" marking!
While in use, regularly check the unit's water level!
Never use the unit without water in the container!
NOTE!
Fill the unit with warm water to save time and energy!
Connect the unit to a single grounded outlet.
Turn the unit on using the ON/OFF switch located on the control panel. The red
standby light inside the switch will come on.
- 21 -

Publicité

loading

Ce manuel est également adapté pour:

1 x 1/1 gn3 x 1/3 gn200.233200.232200.230