Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Retro-Fit Installation
KIT ZKUN PARTS SUPPLIED:
Adhesive Heater
Transformer
Front Mullion
Trim Bracket
Top Unification Bracket
Bottom Front Unification Bracket
3 1/4" Hex Head 8-18 5/8" Long Screws
5 1/4" Hex Head 8-32 5/8" Long Screws
5 3/8" Hex Head 1/4-20 1/2" Long Screws
4 wire clips
Tools and Materials Required:
1/4" and 3/8" driver / sockets
#2 Phillips screwdriver
Rubbing alcohol
STEP 1 REMOVE PACKAGING
WARNING
appliance is top heavy. Use extreme caution with
moving to prevent tipping over which could result in
death or serious injury.
Remove outer carton and external packing from units.
Inspect for damage.
If installation will require the door swing to be
reversed, follow the instructions in Reversing the
Door Swing section to reverse the door swing
BEFORE the unit is removed from the shipping skid.
Ensure the flooring that the units are set is clean/
free of debris that could be collected on to, or
pinched in front of the wheels and damaging the
floor. Additionally, it is recommended that the floor
be protected with a plastic covering through out the
installation process.
Remove hardware kit from top drawer.
If installation requires a
limiter pin must be installed
in the top hinge
BEFORE
the unit is removed from the
shipping skid. Pin is located in
the hardware kit.
- Open the door approximately
45°,
but no wider than
to expose the hole in the
back hinge bracket and
install the limiting pin. Pin
must be fully seated in the
bracket or the door will not close properly.
31-1000190 Rev. 3
Tip Over Hazard.
90°
door opening, the hinge
90°,
STEP 1 REMOVE PACKAGING
(Cont.)
Remove front access cover from unit by removing
two 1/4" Hex Screws (some models have access
cover in a box on the left side of the cabinet).
Place the cover and screws to the side for future
installation.
Remove three 3/8" drive screws and two 7/16" drive
screws from each side of the unit to release it from
the shipping skid. Tip the unit from the side enough
to remove the shipping material from under the unit,
but above the shipping skid (both sides)
CAREFULLY roll the unit off the back side of the
shipping skid.
Handle from side only with a hand truck.
3/8" Drive
Screws
Shipping
Bracket
7/16" Drive
This
Screws
STEP 2 INSTALL WATER LINE
WARNING
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
A cold water supply is required for automatic icemaker
and AutoFill pitcher operation. The water pressure
must be between 40 and 120 p.s.i. (275-827 kPa).
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the
line of water.
Top
Install a shut-off valve between the water valve and
hinge
cold water pipe in a basement or cabinet. The shut-
off valve should be located where it will be easily
accessible.
Turn on the main water supply and flush debris.
Run about a quart of water through the tubing into a
bucket. Shut off water supply at the shut-off valve.
27
1/4" Hex Screws
Connect to potable water supply
ELECTRIC SHOCK HAZARD
Publicité
