geo-FENNEL FKL 44 Mode D'emploi page 19

EN
LASER SPOT CENTERING
Keep both buttons pressed for one second simultaneously and release. Now the laser dot will center
automatically. During the centering procedure the display indication is blinking. When the centering
procedure is completed the display shows
MOVE THE LASER DOT TO THE LEFT / RIGHT
With these buttons the laser dot can be shifted rightwards or leftwards.
Single pressing = slow shifting in the direction selected
Continuous pressing = quick shifting in the direction selected
When shifting the laser dot the below symbols are displayed:
Figure 1: the laser dot is in the most left position
Figure 2: the laser dot is in left position
Figure 3: the laser dot is centered
Figure 4: the laser dot is in right positon
Figure 5: the laser dot is in the most right position
DIRECTION ARROW
GRADE SETTING
Grade setting range: -20 % ~ + 30%
Press the button to select the grade setting mode.
Display indication: "+00.000 %" .
Select all digits for the grade setting with the button.
With the buttons the grade values can be set.
Lowest digit: 0
Maximum digit: 9
When the cursor is on the sign it can be changed from "+" to "-" with the button.
Slow pressing = slow setting of the grade values
Continuous pressing = quick setting of the grade values
Simultaneous pressing of both buttons sets the grade value to „0" again.
When the grade values required have been set press the button to confirm.
When the laser levels the grade symbol is blinking. When the self-levelling procedure has been
completed the blinking stops.
19