• Use on escalators and the like is expressly prohibited!
• Do not hang any bags on the handle – risk of tipping!
• When folding/unfolding the product, clothing and body
parts can be pinched.
• Protect the product from direct sunlight. Product parts
can become hot and cause skin injuries if touched.
• Prior to each use, ensure that your product is intact and
all adjustable parts are properly secured.
• Check the screws on the product regularly and tigh-
ten, if necessary.
• Always place weight on the rear feet of the product
since the walking frame can otherwise roll away – risk
of falls!
• Every serious incident which occurs in connection with
the product must be reported to the manufacturer and
the competent authority of the member state in which
the user and/or patient is located.
Unfolding
Place the folded walking aid in front of your body. Unfold
the walking aid at the handles until the locking mecha-
nism on the telescopic bar clicks into place. Check the
locking mechanism.
Height adjustment of the feet
Ensure that the pushbutton has correctly clicked into
place. Ensure that all four legs are adjusted to the same
height.
Walking
To walk, slightly lift both rear feet and slowly roll the wal-
king frame forward. Then place the rear feet down and
walk.
When walking, do not place the walking aid too far out
in front. Always place the walking aid straight down on a
stable surface.
Take only small steps when using the walking aid and
hold on to the handles. Stand fi rmly when moving the
walking aid.
Drive Medical GmbH & Co. KG | As per: 25.07.2023 | Errors and alterations excepted
Before using the product,
adjust it to the desired
height. To adjust the height
of the legs:
Press button (1) and at the
same time, pull the leg out
or push it in until the button
clicks into place in the desi-
red position (2).
When diagonal to the direction of movement, the wal-
king aid tips at an angle of more than 3.5°.
Only walk if the walking frame is stable.
Folding
Press down the locking mechanism and fold the side
frames inwards.
Cleaning | Maintenance
• Clean regularly with a moist cloth!
• Do not use any aggressive cleaning agents!
• Do not use abrasive cleaners!
• Do not use any high-dose chlorine and vinegar-based
cleaners!
• To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
• Check the screws regularly and tighten, if necessary.
• The product should not be exposed to temperatures
above 60°C for long periods of time (for example, use
in a sauna, etc.).
• In the event of defects, contact your specialist dealer
from whom you purchased this product.
Technical data
Product
Article number
Overall length
Overall width
Overall height
Width between the rear legs
Width between the front legs
Dimensions when folded
Weight
Max. load
Frame material
Instructions for use READY SET GO
EN
Ready Set Go
10263KDR
38 cm
68 cm
74 - 94 cm
54 cm
54 cm
55 x 43 x 12 cm
3,6 kg
100 kg
Aluminium
9