Whirlpool WMW57DHMW Manuel Du Propriétaire page 9

CLEANING AND MAINTENANCE
Make sure that the appliance has cooled down
before carrying out any maintenance or cleaning.
Never use steam cleaning equipment.
INTERIOR AND EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Clean the glass in the door with a suitable liquid
detergent.
• At regular intervals, or in case of spills, remove the
turntable and its support to clean the bottom of the
oven, removing all food residue.
• Activate the "MW Self Clean" function for an
optimum cleaning of the internal surfaces.
• The grill does not need to be cleaned as the intense
heat burns away any dirt. Use this function on a
regular basis.
TROUBLESHOOTING
Problem
The oven is not working.
The oven makes noises, even
when it is switched off.
The display shows the letter "F"
followed by a letter or number.
Keypad does not work as
foreseen. The display shows a
strange visualization.
The oven does not heat up.
Policies, standard documentation and additional product information can be found by:
• Using the QR code in your appliance
• Visiting our website docs.whirlpool.eu/docs
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-
•
sales Service, please state the codes provided on your product's identi cation plate.
Do not use wire wool, abrasive scourers or abrasive/
corrosive cleaning agents, as these could damage
the surfaces of the appliance.
ACCESSORIES
All accessories are dishwasher safe with the exception
of the Crisp plate.
The Crisp plate should be cleaned using water and
a mild detergent. For stubborn dirt, rub gently with
a cloth. Always leave the Crisp plate to cool down
before cleaning.
Possible cause
Power cut.
Disconnection from the
mains.
Cooling fan active.
Software fault.
Keylock has been activated
(see Keylock section).
When "DEMO" is "On" all
commands are active and
menus available but the oven
doesn't heat up.
Solution
Check for the presence of mains electrical power
and whether the oven is connected to the
electricity supply. Turn o the oven and restart it to
see if the fault persists.
Wait until the cooling process has nished.
Contact you nearest After-sales Service Centre and
state the letter or number that follows the letter "F".
Disable the keylock by following the indications
within Keylock section.
To exit DEMO mode, follow this procedure: press
°C/W, , °C/W, , °C/W,
total). You will hear a beep signal that the operation
has been successful. The clock ashes waiting for
the hour setting.
At this point, the oven is ready to be used.
in sequence (6 taps in