Whirlpool WMW57DHMW Manuel Du Propriétaire page 6

FIRST TIME USE
1. SETTING THE TIME
You will need to set the time when you switch on the
oven for the first time.
The two digits for the hour will start flashing: Turn the
knob to set the hour and then press
The two digits for the minutes will start flashing. Turn
the knob to set the minutes and press
Please note: To change the time at a later point, press and
hold for at least one second while the oven is o and
repeat the steps above. You may need to set the time again
following lengthy power outages.
DAILY USE
1. SELECT A FUNCTION
When the oven is off, only the time is shown on the
display. Press and hold
the knob to view the main functions available on
the left-hand display. Select one and press
function currently in selection will blink, and will
stop blinking after the press of the knob (i.e. after its
selection).
To select a sub-function (where available), select the
main function and then press
the function menu.
Turn the knob to select from amongst the
subfunctions available on the right-hand display and
then press to confirm. The sub-function in selection
will blink until its confirmation.
2. SET A FUNCTION
. AUTOMATIC FUNCTIONS / JET DEFROST
FOOD CLASS
Once you have chosen one of the automatic
functions, you will need to select a category for the
food you are cooking.
to confirm.
to confirm.
to switch the oven on. Turn
. The
to confirm and go to
2. HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal. Before starting to cook food, we therefore
recommend heating the oven with it empty in order to
remove any possible odours. Remove any protective
cardboard or transparent lm from the oven and
remove any accessories from inside it. Heat the oven
to 200 °C for around one hour, ideally using a function
with air circulation (e.g. "Forced Air").
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the rst time.
When the icon flashes, turn the knob to select the
category you require and then press
Categories are shown on the stickers applied on the
inner door frame.
WEIGHT
To achieve the best results, the automatic functions
(and Jet Defrost) require you to enter the weight of
the food, selecting from amongst the default settings:
the oven will calculate the ideal length of time for the
function to run for each category of food.
When the default setting appears on the display and
the icon flashes, turn the knob to set the weight
and then press to confirm.
. MANUAL FUNCTIONS
After having selected the function you require, you
can change its settings.
The display will show the settings that can be
changed in sequence.
to confirm.