Publicité
Les langues disponibles
Les langues disponibles
Take off the control lever
Loosen the cartridge end ring
screw off the cartridge locking ring
a pipe wrench.
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge.
Place the setting ring in the desired position as
shown in fig. J.
Note: The setting ring
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
tap body
again by using a pipe wrench, then
23
tighten the cartridge end ring
Place the control lever
body
and tighten the locking screw by turn-
23
ing it clockwise using a hexagonal key.
Press the cap
into the opening.
19
Turn on the main water supply and check the
temperature limiter.
Water-saving function
The cartridge
in this tap has an Eco-Click
22
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. K).
Lift the lever
until you notice a slight resist-
16
ance. This resistance will cause a stop in case
of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
the resistance.
Energy-saving function
The cartridge
in this tap has an energy
22
saving function.
Only cold water will flow out when the control
lever
is set to the middle position, and thus
16
reduce energy comsumption (see fig. L).
8
GB/IE/NI
.
16
by hand, then
20
by using
21
upwards with the
24
can limit the turning
24
onto the
21
by hand.
20
back on to the tap
16
until you overcome
16
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special care
and attention. Therefore you should follow the fol-
lowing advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild deter-
gent and a soft cloth or leather only.
Screw out the mixer nozzle
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
at regular intervals
17
Publicité
