Moulinex Turbo Cuisine Maxi CE778810 Mode D'emploi page 111

5. How to use safely – during cooking?
• Do not try to open the lid until the pressure has
decreased sufficiently. Do not try to open the lid until
the float valve is down.
• Never force the appliance open.
• During cooking and steam release at the end of cooking,
the appliance releases heat and steam. Keep your face
and hands away from the appliance to avoid burns. Do
not touch the lid during cooking.
• Do not move the appliance when it is under pressure.
Use the handles when moving it and wear oven mitts, if
necessary. Do not use the lid knob to lift the appliance.
• Do not remove the cooking pot while the appliance is
working.
• In browning mode, be careful of risks of burns caused
by spattering when you add food or ingredients into
the hot cooking pot.
6. How to use safely – after cooking?
• When you open the lid, always hold it by the lid knob.
Position your arm parallel to the side handles. Boiling
water could remain trapped between the sealing gasket
and the lid and could cause burns.
• Be careful also about the risk of burns from the steam
coming out of the appliance when you open the lid.
First open the lid very slightly to allow the steam to
escape gently.
• Do not touch hot parts of the appliance. After use,
heating plate surface can remain hot for up to 2 hours.
214
• Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking off parts.
7. How to use safely – cleaning?
• Wipe clean the bottom of the cooking pot and the
heating plate after every use.
• Do not immerse the appliance in water.
• For cleaning your appliance, please refer to instructions
for use. You can wash the cooking pot and the lid in
soapy hot water, do not put them in the dishwasher.
Clean the housing of the appliance using a damp cloth.
8. What to do in case of damage?
• Only authorized person in Approved Service Centre can
repair the product.
• Do not operate any appliance with a damaged power
cord or plug or after the appliance malfunctions or has
been damaged in any manner. Return appliance to
the nearest Approved Service Centre for examination,
repair or adjustment.
• If the power cord is damaged, it must be replaced by an
Approved Service Centre in order to avoid a hazard. Do
not replace the power cord supplied with other cords.
• Do not damage the sealing gasket. If it is damaged,
have it replaced in an Approved Service Centre.
• Replace the sealing gasket every 2 years, or sooner
if you see the sealing gasket is worn or in need of
replacement.
EN
215