Publicité
Les langues disponibles
Les langues disponibles
Prepare Built-In Oven
NOTES:
Refer to the following "Installation Instructions" and
■
the "Installation Instructions" section of the Installation
Instructions provided with your built-in oven.
Refer and adhere to the "Electrical Requirements"
■
section, and complete the instructions in the "Make
Electrical Connection" section of the Installation
Instructions provided with your built-in oven.
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior
to installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials that
may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5. Move oven and cardboard close to the oven's final location.
Remove Oven Door(s)
IMPORTANT: Use two hands to remove oven door(s).
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be flat and covered with
a soft blanket, or use the corner posts from your packaging
material.
2. Open the oven door.
3. Locate the oven door hinge locks in both corners of the oven
door, and rotate the hinge locks toward the oven door to the
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
A Oven door hinge lock
in locked position
INSTALLATION INSTRUCTIONS
A
B. Oven door hinge lock in
partially unlocked position
4. Partially close the door to engage the door latch locks. The
door will stop at this point.
5. Using two hands, grasp the edges of the oven door. Lift and
pull the oven door toward you, and remove. You may need to
gently shift door from side to side as you pull.
6. Set the oven door(s) aside on the prepared covered work
surface with the oven door resting on its handle.
7. To continue with the oven installation, go to the "Positioning
Oven Feet" section.
B
5
Publicité
