Waeco PerfectPower PP300 Notice D'emploi page 9

Collected_MB-830_q6.qxd
Error
No output voltage
Alarm tone during the operation
Unit switches On/Off cyclically
The inverter switches off when
the power consuming unit is
switched on.
Article No.
Input nominal voltage:
Permanent output capacity (>4 hrs.):
Permanent output capacity (30 min.):
Peak output capacity (0.1 sec.):
Output voltage
Output frequency:
Efficiency with nominal output:
No-load current consumption:
Maximum ambient temperature:
Dimensions W x H x D (mm):
Weight
Subject to changes due to technical progress and availability.
Reference! The output voltage of this rectangle inverter can be measured only correctly with an analog indicator
(pointer instrument).
08.06.2004 15:20 Uhr
All manuals and user guides at all-guides.com
Error detection
Cause
Battery voltage is smaller than
10 V (830-012PP)
or 20 V (830-024PP)
Thermal overload
Fuse is defective (in the Perfect
Power or in the vehicle)
Battery voltage is under
10.7 V (830-012PP)
or 21.4 V (830-024PP)
Poor contact at the battery with
load
Permanent load is too high
Switch-on current is too high
Technical data
830-012PP
European plug
10 V~15 V +/- 0.3 V
280 W
300 W
600 W
210-230 V AC
<0.15 A
105 x 57 x 165 103 x 65 x 205
0.7 kg
Seite 9
Troubleshooting
Load battery (start motor)
Switch off power consuming unit
let PerfectPower cool down and
provide for better ventilation
Fuse to be replaced by a
qualified electrician
Charge battery
Cleaning the contacts
Reduce load
Comparison of the unit capacity
with the maximum capacity of
the device
Safety plug/UK version European plug
50 Hz
90 %
40 °C
105 x 57 x 165 103 x 65 x 205
0.8 kg
9
830-024PP
Safety plug/UK version
20 V~30 V +/- 0.6 V
280 W
300 W
600 W
210-230 V AC
50 Hz
90 %
<0.15 A
40 °C
0.7 kg 0.8 kg