Waeco PerfectPower PP300 Notice D'emploi page 8

Collected_MB-830_q6.qxd
1. Inverter
2. connecting cable with battery terminals
3. operating instructions
To start-up the inverter, connect the red
terminal with the positive pole (+) of the
battery and the black terminal with the
negative pole (-) of the battery.
Make sure that the poles are clean when
connecting the battery.
1 230 V AC output
2 "ON/OFF" control light-emitting diode
green
3 ON/OFF Switch
4 control light-emitting diode red
(overload- and undervoltage display)
5 Positive contact (red terminal)
6 Negative contact (black terminal)!
Caution! Length and cross-section of the
connecting cable are synchronized to each
other!
Do not modify without authorisation.
The start-up can be done with the "ON/OFF"
switch. The green control light-emitting diode
"POWER" lights up in the switch position "ON".
Should the battery voltage fall below 10.7 V for
21.4
830-012PP or 12.4 V for 830-024PP during
operation, an audible signal is emitted and the
red control light-emitting diode illuminates. The
inverter switches off if the battery voltage drops
further. When the heating is too strong, the
inverter switches off — the red control light-
emitting diode illuminates. Switch off the inverter
by means of the "ON/OFF" switch. The inverter
can be switched on again after it has cooled
down. When operating the PerfectPower during
longer period of time and with the largest load, it
is recommendable to start the motor in order to
08.06.2004 15:20 Uhr
All manuals and user guides at all-guides.com
Scope of delivery
Installing the inverter
Commissioning of the inverter
Seite 8
The illustration shows the European version of
the inverter. The 230 V output on the device is
country specific.
Make sure that the polarity will not be
exchanged! Reverse polarity connection
will blow the internal fuses. Exchange of
fuses by experts only!
recharge the battery of the vehicle. The inverter
can be operated with the motor running or
switched off. However, the motor should not be
started if the PerfectPower is switched on, since
the power supply to the cigarette lighter could
be interrupted during the start process.
8