EINHELL 4600015 Mode D'emploi page 21

Remove the adapter plate (Item 18) from the bar
as shown in Fig. 29. Now fi t the adapter plate to
the new bar. Proceed as described in the section
"Assembly of the bar and the saw chain".
Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis
in order to guard against overheating and the
damage this can cause to the bar and the chain.
Point the tip of the bar at a smooth surface (a
board or a cut tree face) and allow the chain saw
to run.
If you see a growing oil stain on the smooth
surface, the automatic chain lubrication system
is working properly. If no clear oil trace is
evident then please refer to the corresponding
instructions in "Troubleshooting". If the information
contained there still fails to remedy the situation,
please contact our service department or another
similarly qualifi ed workshop.
Danger! Do not actually touch the surface with
the tip of the bar when performing this test. Keep
a safe distance (approx. 7.8").
Sharpening the chain
Working eff ectively with the chain saw is only
possible if the chain is in good condition and
sharp. This also reduces the risk of kickback.
The chain can be re-sharpened by any dealer.
Do not attempt to sharpen the chain yourself
unless you have the necessary special tools and
experience.
9. Notes on environmental
protection / disposal
The equipment must be properly disposed of
when it reaches the end of its service life. The
equipment must not be disposed of as domestic
waste. Instead, in the interests of the environment
it should be disposed of via a designated
recycling or disposal point for electrical
equipment. Please contact your local authorities
for information about proper disposal of the
equipment in your area. Packaging materials and
worn accessory parts should also be disposed of
at the designated recycling or disposal points.
Anl_Fortexxa_18_30_SPK7_USA.indb 21 Anl_Fortexxa_18_30_SPK7_USA.indb 21
EN
10. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 21 -
22.08.2023 14:48:49 22.08.2023 14:48:49