Noise - Haier HLPW028BXW Instructions D'installation Et Guide De L'utilisateur

PROBLEM
Water leaks
Water will not
drain from
washer
Water runs out
of drain hose
when tub is
filling

NOISE

PROBLEM
Thumping
Rattling or
Clanking
Squealing
Vibration
POSSIBLE CAUSE(S)
Water inlet hoses are not
connected correctly.
Water hose connections are
not tight.
Drain hose connection is
not secure or the hose is
not properly positioned in
the drain.
Undetermined water leaks
Drain hose is not properly
connected to the washer.
Drain hose is not positioned
properly.
Sink or drainpipe is clogged.
The end of the drain hose is
too low.
NOTE:
If the end of
the drain hose is lower
than the maximum tub
water level, the wash
tub will not fill or hold
water properly.
POSSIBLE CAUSE(S)
Wash load may be
unbalanced.
Washer may not be level.
Coins, buttons or other
foreign objects may be in
the washer.
Washer may be overloaded.
Washer may not be level.
SOLUTION
Make sure the inlet hoses are
properly connected (hot to hot
and cold to cold).
Make sure the inlet hose
connections at the faucets
and washer are tight.
Make sure the drain hose
connection at the washer is
secure and that the drain hose
is properly positioned at the
drain location.
Call a qualified plumber.
Reconnect drain hose to the
washer.
In order to drain properly, the
top of drain outlet must not be
higher than 60" (153 cm)
above the floor.
Remove blockages from the
sink or drainpipe.
Position the top of the drain
hose so that it is at least 39"
(99 cm) above the floor.
SOLUTION
Pause the washer and
redistribute items in the wash
basket.
Level the washer. See "Level
the Washer."
Stop the washer and check for
keys or coins and other foreign
objects.
Stop the washer and remove
part of the wash load.
Check that all four legs are
resting firmly on the floor and
that the washer is level.
33