Publicité
Les langues disponibles
Les langues disponibles
oil and grease. Greasy, oily handles are
slippery causing loss of control.
4. Do not operate the product with a slack
chain. A slack chain may jump off the
guide bar and cause serious or even
fatal injury.
5. Keep all parts of the body away from
the saw chain when the chain saw is
operating. Before you start the chain
saw, make sure the saw chain is not
contacting anything and free from
obstructions. A moment of inattention
while operating chain saws may cause
entanglement of your clothing or body
with the saw chain.
6. Shut off the engine before setting the
product down.
7. Before using the product and after
any impact or dropping, check for
signs of wear or damage and repair as
necessary.
1. When sawing, ensure the product does
not touch any foreign materials such as
rocks, fences, nails etc. Such objects
may be flung out and could result
in damage to the product or serious
personal injury or even death.
2. Never operate the product on a ladder
or other insecure support.
3. If the chain jams in the cut: STOP THE
ENGINE. Do not try to pull the product
free. Use a lever to open the cut and
free the chain. Failure to do so could
result in serious injuries or death.
4. Only cut with the engine at high
speeds.
5. Use extreme caution when cutting
small size bushes and saplings.
Slender material may catch the saw
chain and whip toward you or put you
off balance.
6. Operate the product only in well
ventilated areas.
7. This product is intended for two handed
use only, with your right hand on the
rear handle and your left hand on
the front handle. You cannot control
reactive forces and you may lose
control of the saw, which can result in
the skating or bouncing of the bar and
chain along the limb or log.
8. Do not operate the product if you have
WWW.SENIXTOOLS.COM
any medical conditions that might be
aggravated by strenuous work. Check
with your doctor before operating this
product.
9. Do not operate the product under
the influence of drugs, alcohol or
medication.
10. Do not touch muffler or the exhaust
during use - IT GETS VERY HOT.
11. Do not operate a product that is
damaged, improperly adjusted, or not
completely and securely assembled.
Be sure that the saw chain stops
moving when the throttle trigger is
released.
12. Do not operate this product in a tree
unless you have been specifically
trained to do so. Operation of the
product while up in a tree may result in
personal injury.
13. Do not operate your product near or
around flammable liquids or gases.
14. Do not smoke while operating the
product.
15. Do not grip the handles with constant
or excessive pressure; this will increase
the feeling of vibration and the risk of
"white finger" disease.
16. Do not over reach when operating the
product or cut above shoulder height.
17. Do not operate the product if it is
leaking fuel, engine oil or chain oil.
18. When cutting a limb (branch) that is
under tension, be alert for spring back
so that you will not be struck when the
tension in the wood fibres is released.
19. Always keep proper footing and
operate the chain saw only when
standing on fixed, secure and level
surface. Slippery or unstable surfaces
such as ladders may cause a loss of
balance or control of the chain saw.
20. Cut wood only. Do not use the product
for purposes not intended. For
example: do not use chain saw for
cutting plastic, masonry or non-wood
building materials. Use of the chain
saw for cutting plastic, masonry or non-
wood building materials. Use of the
chain saw for operations different than
intended could result in a hazardous
situation.
5
Publicité
