Senix CS4QL-L3 Manuel D'utilisation page 11

Before use of this product, familiarize yourself with all
operating features and safety rules.
Before beginning work, inspect the chain saw for damage
to the housing, the saw chain and the guide bar. Never
use an obviously damaged machine.
The choke knob opens and closes the choke valve in the
carburetor. Positions available include FULL CHOKE and
RUN.
A spark plug wrench and a torx wrench tool is provided
for use when performing various maintenance
procedures.
In addition, the spark plug wrench can be used to adjust
the chain tensioning.
The chain brake is designed to quickly stop the chain
from rotating. When the chain brake / front hand
guard is pushed toward the bar, the chain should
stop immediately. The chain brake does not prevent
kickback.
Check the tension and the condition of the chain.
The sharper the saw chain is, the easier and more
manageable operations will be. The same applies to
chain tension. Check the tension every 10 minutes
of operation to maximize safety. New saw chains
in particular are subject to changes due to the heat
created by operation.
The primer bulb pumps fuel from the fuel tank to the
carburetor.
The throttle trigger is used for controlling the chain
speed.
Make absolutely sure to wear the appropriate close-
fitting protective clothing such as protective pants,
gloves and safety shoes.Wear a helmet,hearing
protection and a face guard to provide protection
against falling and recoiling branches.
Align and push the Guide bar cover onto the chain and
guide bar to attach it.
WWW.SENIXTOOLS.COM
If any part of the chain saw is missing or damaged,
do not use the chain saw until the damaged part is
repaired or replaced.
Chain and bar oil is not included. You must fill
the chain oil tank with bar and chain oil before use.
Remove the guide bar cover before use.
46cc Chain saw X1
Bottle of engine oil X1
Torx wrench X1
Spark plug wrench X1
Guide bar cover X1
Quick start guide X1
Operation's manual X1
The Chain Saw comes fully assembled. DO NOT
discard box or packing material until all parts are
examined.
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
ALWAYS Maintain proper chain tension. A loose chain
will increase the risk of kickback. A loose chain may
jump out of guide bar groove. This may injure operator
and damage chain. A loose chain will cause chain,
guide bar, and sprocket to wear rapidly. The chain
life of the saw chain mainly depends upon sufficient
lubrication and correct tensioning. Avoid tensioning the
chain if it is hot, as this will cause the chain to become
over tensioned when it cools down.
11