Senix CS4QL-L3 Manuel D'utilisation page 21

Always switch the product off, disconnect the spark plug
wire and let the product cool down before performing
inspection, maintenance and cleaning work!
Maintain this product regularly and carefully! If the
product is improperly maintained, it may fail at its
intended task, which may produce fatal consequences.
1. Keep the product clean. Remove debris from it after
each use and before storage.
2. Regular and proper cleaning will help ensure safe
use and prolong the life of the product.
3. Inspect the product before each use for worn and
damaged parts. Do not operate it if you find broken
and worn parts.
Only perform repairs and maintenance work according
to these instructions! All further works must be
performed by an authorized service dealer!
1. Clean the product with a dry cloth. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents after every use with
a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3
bar).
4. NOTE: Do not use chemical, alkaline, abrasive
or other aggressive detergents or disinfectants to
clean this product as they might be harmful to its
surfaces.
5. Check for any damage and wear. Repair damages
in accordance with this instruction manual or take
it to an authorized service center or a similarly
qualified person before using the product again.
Inspect and maintain this product regularly based on
below maintenance table.
Part To do Before/
after
each use
Spark plug Check
Spark plug Clean
Spark plug Replace Whenever necessary
Air filter Check x
Air filter Clean x
Air filter Replace Whenever necessary
Saw chain Check x
Saw chain Lubricate x
Saw chain Clean x
Saw chain Replace Whenever necessary
Engine oil Check x
Engine oil Replace After the first 8 hours
WWW.SENIXTOOLS.COM
10h 25h 50h/ 100 h/
half once a
year year
x
x
for machine in ordinary operation condition. If there
is any abnormal sign of the machine, please do the
proper inspection and maintenance immediately.
customer service for help.
mentioned here shall only be done by an authorized
service dealer.
1. Clean the sprocket wheel.
2. Using a disposable lube gun, insert the needle nose
into the lubrication hole and inject grease until it
appears at the outside edge of the sprocket(Fig.31).
Fig. 31
3. Make sure that the chain brake is disengaged.While
wearing gloves rotate the saw chain. Repeat the
lubrication procedure until the entire sprocket has
been greased.
Most guide bar problems can be prevented merely by
keeping the product well maintained. Incorrect filing and
non-standard cutter and depth gauge settings are the
causes of most guide bar problems, primarily resulting
in uneven bar wear. As the bar wears unevenly, the
rails widen, which may cause the chain to clatter
and make it difficult to complete straight cuts. If the
guide bar is insufficiently lubricated and the product is
operated with a saw chain which is too tight, this will
contribute to rapid bar wear. To help minimize bar wear,
maintenance of the guide bar as well as the saw chain
is recommended.
21