Senix CS4QL-L3 Manuel D'utilisation page 20

3. When the log is supported on both ends, cut 1/3 the
diameter from the top (overbuck). Then make the
finished cut by underbucking the lower 2/3 to meet
the first cut(Fig.26).
Fig. 26
4. When bucking on a slope always stand on the uphill
side of the log. When "cutting through", to maintain
complete control release the cutting pressure near
the end of the cut without relaxing your grip on
the product handles. Do not let the chain contact
the ground. After completing the cut, wait for the
saw chain to stop before you move the product.
Always stop the engine before moving from tree to
tree(Fig.28).
Fig. 28
20
5. Support small logs on a sawing stand or another log
while bucking(Fig.29).
Fig. 29
6. If the wood diameter is large enough for you to
insert a soft bucking wedge without touching the
chain, you should use the wedge to hold the cut
open to prevent pinching(Fig.30).
Fig. 30
WEDGE
WWW.SENIXTOOLS.COM