Publicité
Les langues disponibles
Les langues disponibles
STEP 1: PRELIMINARY INSTALLATION INSTRUCTIONS
Installation requires TWO PEOPLE at all times, as installation will block the attic door for an extended
period of time while one installer is in the attic. Installers must stay in verbal contact with each other.
Temperatures in attics can be much hotter than home and outside temperatures. Extreme heat in attics can cause
heat exhaustion (e.g., dizziness, headaches, severe sweating, dehydration, cramps) that may impede your ability to
complete this installation. Stay in verbal contact with the other installer and stay well hydrated.
Installer #1 will work from the floor and Installer #2 will work from the attic.
The following instructions explain the tasks for each installer.
Prepare the attic ladder for installation into the rough opening.
A. Position the attic ladder on a flat horizontal work surface.
B. Install the plastic bushings from the outside of the aluminum frame by pressing or tapping lightly with a rubber mallet into
the predrilled holes in the position shown in
NOTE: Be sure each plastic bushing is fully inserted and aligned in the holes, otherwise they may become loose or damaged
during the installation.
5
DO NOT INSTALL DURING EXTREME HEAT.
Figure 3
. Alternative footer bushing holes will be drilled later, if needed.
F
3:
IGURE
BUSHING LOCATIONS
Publicité
