Publicité
Les langues disponibles
Les langues disponibles
F
18:
(
SECTION N)
IGURE
ALTERNATIVE INSTALLATION
SEE NOTE ON
Figure 19
O. Installer #1: Remove the temporary wood support boards "A" and "B" from the ceiling. See
F
19 :
IGURE
REMOVING TEMPORARY SUPPORT BOARDS
P. Installer #2 Make sure no materials are stored on the attic ladder door as these may fall when opening the door.
Installer #1 and #2: Carefully open the attic ladder door and make sure the spreader bars are fully extended to avoid
unexpected door closure.
IMPORTANT: If the frame is not square the attic door may not open and close properly.
Materials needed:
Q. Installer #1:
Attaching pull cord: Thread the pull cord through the
pre-drilled hole in the attic ladder door. Place the ¼" x 1"
washer on the top side of the attic door panel and tie a
knot in the end of the cord. The length of the cord can be
adjusted after the ladder is completely installed.
Be sure the knot is large enough, so it does not slip back
Figure 20
through the hole. See
.
F
20 :
IGURE
ATTACHING PULL CORD
11
Publicité
