Publicité
Les langues disponibles
Les langues disponibles
C)
Remove the plastic floor from the base of the incubator, as it is
necessary only for hatching (last 3 days). DO NOT LEAVE IT INSIDE THE
MACHINE DURING INCUBATION!
NB: store the plastic floor on a flat surface so that it won't deform.
D)
Ensure that the egg tray is in the correct position (on its supports) and that the cradle rows tilt freely in the two
directions.
E)
Fill basin 5/a with lukewarm water. Pour the water into the
corresponding opening at the left hand side of the incubator. Do this
slowly, taking care not to allow the water to overflow from the basin: too
much liquid would increase in the humidity rate lowering the hatching
percentage. The second basin (5/b) will be used only for the hatching
phase.
F)
Replace the lid. Ensure that the edge of the lower box locates perfectly
with the slot in the lid.
For both models it is possible to place the lid so that the openings for
water filling are at the front or at the back of the incubator.
Chasse
Pêche
27
Loisir et nature
www.ducatillon.com
Jardin
Élevage
Publicité
