Publicité
Les langues disponibles
Les langues disponibles
9
Overview of the unit
6) For additional heat source control:
Power supply
Additional heat source
Voltage
Maximum running current (A)
Wiring size (mm
)
2
Control port signal type
Warning:
This part only applies to the unit
A
without an interval backup heater.
If there is an interval backup heater
in the unit, the hydraulic module
should not be connected to any
additional heat source.
Voltage
Maximum running current (A)
Wiring size (mm
)
2
Control port signal type
Heat Pump Monobloc Inverter / User Manual
7) For outside circulation pump P_o:
220-240~VAC
0.2
Voltage
0.75
Maximum running current (A)
Type 2
Wiring size (mm
Control port signal type
a) Procedure
•
•
220-240~VAC
0.2
0.75
Type 1
Power supply
)
2
Connect the cable to the appropriate
terminals as shown in the picture.
Fix the cable with cable ties to the cable tie
mountings to ensure stress relief.
220-240~VAC
0.2
0.75
Type 2
85 / 276 EN
Publicité
