Publicité
Les langues disponibles
Les langues disponibles
EN
is binding, never attempt to remove the product
from the material or pull the product backward
while the blade is in motion, otherwise blade thrust
may occur. Investigate and take corrective actions to
eliminate the cause of blade binding.
c) Do not use blunt or damaged blades. Blunt
or damaged blades increase the risk of jamming or
catching on an object, resulting in blade thrust.
d) Always maintain good visibility of the material
being cut. Blade thrust is more likely to occur in areas
where it is difficult to see the material being cut.
e) If you are approached by another person while
operating the product, switch the product off.
There is an increased risk of injury to other persons
being struck by the moving blade in the event of blade
thrust.
3
SERVICE
Servicing requires extreme care, and knowledge
and must be performed only by a qualified service
technician. Consult your nearest AUTHORIZED
SERVICE CENTER for repair. Call 1-855-470-4267 to
obtain the address. Only use identical manufacturer's
replacement parts and accessories from the
AUTHORIZED SERVICE CENTER.
4
ASSEMBLY
This section describes how to assemble and adjust the
product.
CAREFULLY READ AND UNDERSTAND THE
SAFETY CHAPTER AND THE ASSEMBLY
INSTRUCTIONS BEFORE YOU ASSEMBLE THE
PRODUCT.
4.1
INSTALL THE BIKE HANDLE
1.
Lay the bike handle in the lower support.
2.
Position the cap on the lower support. Insert the
latches on the cap into the slots on the lower
support.
3.
Insert the spring followed by the bike handle
housing onto the shaft.
WARNING
English
4.
Adjust the bike handle to a comfortable position.
5.
Lock the bike handle with the wing bolt.
4.2
INSTALL THE CUTTING EQUIPMENT
The cutting equipment includes a cutting attachment
and a cutting attachment guard. The product has
different cutting attachment guards and cutting
attachments. Make sure that you use the correct
cutting attachment guard for each cutting attachment,
as pictured below.
• Trimmer guard and trimmer head.
• Brush cutter guard and brush cutter blade.
8
Publicité
