Publicité
Les langues disponibles
Les langues disponibles
5.
Replace with a new spool.
Note: If any parts of the spool assembly are damaged
or worn, replace the damaged part.
6.
Place the location housing and slot cover onto the
spool cover, then put the spool onto the slot cover
to the desired position.
7.
Tighten with the screws.
8.
Align the spool tabs with the tab openings on the
spool housing.
9.
Push the spool cover assembly until it clicks into
position.
6.7
INSTALL THE CUTTING LINE
Note: Do not use more than 34' (10.3 m) of 0.095" (2.4
mm) cutting line at a time.
1.
Remove any leftover cutting line from the trimmer
head.
2.
Push and turn the spool cover. Ensure that the
slot on the spool cover aligns with the line exit
hole on the trimmer head.
English
5
4
3
2
1
21
3.
Feed the cutting line through the hole and push it
until it exits the opposite hole.
4.
Pull the cutting line through until there is an equal
amount of cutting line on each side.
5.
Turn the spool cover clockwise to wind the cutting
line into the trimmer head. Keep approximately
5" of cutting line above out of each side of the
trimmer head.
EN
Publicité
