Publicité
Les langues disponibles
Les langues disponibles
10. CLEANING
The grease filters, bottom panel, intake ring (A) and blower wheel (B) should
be cleaned frequently. Use a warm detergent solution. The grease filters,
intake ring and blower wheel are dishwasher safe.
Clean all-metal filters in the diswasher using a non-phophate detergent.
Discoloration of the filter may occur if using phosphate detergents, or as a
result of local water conditions — but this will not affect filter performance.
This discoloration is not covered by the warranty.
To remove the blower wheel, first take off its intake ring. Then remove the
blower wheel by pulling it down smoothly.
NOTE: Do not try to remove the black part (C) attached to the bottom panel.
When reinstalling the blower wheel, make sure the small tab (D) will fit into
one hole of the motor.
S
:
TAINLESS STEEL CLEANING
Do:
• Regularly wash surfaces with clean cloth or rag soaked
with warm water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe completely dry.
• You may also use a specialized household stainless steel
cleaner.
Avoid: when choosing a detergent
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should
never be used close to a range.
E
:
NAMEL FINISH
Clean with warm water and mild detergent only. If discoloration occurs, use a good enamel polish such as automotive polish.
(DO NOT use rough abrasive cleaner or porcelain cleaner.)
C
HD0221
HD0156
Don't:
• Do not use any steel or stainless steel wool or any other
scrapers to remove stubborn dirt.
• Do not use any harsh or abrasive cleansers.
• Do not allow dirt to accumulate.
• Do not let plaster dust or any other construction residues
reach the hood. During construction or renovation, cover
the hood to make sure no dust adheres to stainless steel
surface.
- 9 -
B
A
D
Publicité
