Gladiator GEARLOFT GAWA45SFTG Instructions D'assemblage page 3

Install the GearLoft™ Shelf to the
IMPORTANT:
Be sure the Gladiator GearWall
®
■
channels are installed with mounting screws in every slot
and at every stud location with a maximum of 24" (60.96 cm)
horizontally between screws.
If Gladiator GearTrack channels will be used to mount the
® ®
■
GearLoft™ shelf, they must be installed 6" (15.24 cm) apart.
6" (15.24 cm)
1. Determine shelf mounting location on GearWall
GearTrack channels.
®
2. Insert the brackets into the GearTrack
bracket rim extension fits behind the upper channel groove.
3. Slide the brackets in the channel so they are
spaced 43" (109.22 cm) apart, as shown.
NOTE: Install brackets into the upper channel for installations
with the braces above the shelf, or into the lower channel for
installations with the braces below the shelf.
43" (109.22 cm)
4. Engage the bracket that is welded to the back of the shelf
into the wall slot by lifting up, pushing toward the wall
and lowering the bracket rim into the slot as shown.
For warranty information:
In the U.S.A. call 1-866-342-4089 or visit our website at
www.gladiatorgarageworks.com
In Canada call 1-800-807-6777 or visit our website at
www.gladiatorgarageworks.ca
Wall
panels or GearTrack
® ®
panels or
®
channel so that
®
WARRANTY
5. Make sure the screws on the brackets go through
the holes in the braces. Fasten the braces to
the brackets using the wing nuts (F11).
NOTE: You may need to adjust the brackets to the right or left
if the screws do not align with the holes.
6. Inspect the shelf from the side to ensure the bracket rims are
fully engaged in the slots as shown.
A. Mounting brackets fully engaged in slots
7. Completely tighten the wing nuts (F11).
A
3