Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Q
UICK GUIDE TO SOLVING PROBLEMS
Problem
Possible Cause
Display doesn't come on.
The battery is low
No signal from the controller
The display is on but there
The battery is low
is no signal. The battery
symbol is flashing
The
The
symbol has
symbol has
Controller not properly connected
appeared on the display*
to the belt
and/or the controller is
The GelPads are on the wrong
beeping
way around
The covers are still on the GelPads
The GelPads are worn
The GelPads are not covering the
metal studs
Build up of gel on the metal studs
Poor GelPad contact with the skin
The GelPads are worn
Unpleasant feeling beneath
the GelPads
Build-up of gel on the metal studs
GelPads are not covering the
metal studs
Too many consecutive sessions
The contractions are very
The GelPads are worn
weak even when the toning
intensity is high
The battery is low
Poor GelPad positioning
GelPads are not covering the
metal studs
"Err" appears on the display
Error message
* The
* The
symbol always appears in conjunction with the left/ right intensity indicators. If the left
symbol always appears in conjunction with the left/ right intensity indicators. If the left
indicator appears, there is a problem with the left GelPad, the right indicator acknowledges a
problem with the right GelPad and if both indicators appear there is a problem with the either
the middle pad or all three GelPads.
14
Solution
Recharge the battery
Recharge the battery
Ensure the controller and belt are properly
connected
Ensure the black surfaces of the GelPads
are facing you
Remove the covers from the GelPads
Visit www.slendertone.com or contact
Customer Care for replacement GelPads
Make sure the GelPads fully cover the
metal studs
Clean the metal studs with a clean, dry
cloth
Press the GelPads firmly against the skin.
Refasten the belt properly. Smear a few
drops of water on the surface of the Gel-
Pads. Make sure the controller is OFF first
Visit www.slendertone.com or contact
Customer Care for replacement GelPads
Clean the metal studs with a clean, dry
cloth
Make sure the GelPads fully cover the
metal studs
You should just do one session per day
on any single body area
Visit www.slendertone.com or contact
Customer Care for replacement GelPads
Recharge the battery
See pages 7-8 for correct positioning
Make sure the GelPads fully cover the
metal studs
Switch the controller off and on. The con-
troller should work without any problem.
If the error message persists, contact
Customer Care for advice
H
OW DOES MUSCLE STIMULATION TECHNOLOGY WORK
How does muscle stimulation technology work?
6 uses electronic muscle stimulation (EMS). This technology has been used in
SLENDERTONE ABS
hospitals and by physical therapists for over 60 years. Here is a summary of how EMS
technology works. The patented
SLENDERTONE
muscles contract and not only those directly under the GelPads.
Step 1
Signals are sent
The signals switch on
between the GelPads
the nerves which control
the abdominal muscles.
6 has all the components of an effective abdominal toner.
SLENDERTONE ABS
1. Your product has 21µC (micro coulombs) of toning power. This allows you to generate
strong, effective muscle contractions.
2. Your
6 uses large, medical-grade GelPads. These ensure that your workout is
SLENDERTONE ABS
comfortable.
3. The toning belt's EMS technology has been clinically tested and is proven to give you
firmer, stronger, more toned abdominal muscles in 6-8 weeks.
4. Your product has seven programs which cater to a whole range of training levels from the
beginner to advanced users.
: Your toning belt will not help you lose weight. For this you need to do some form of
NOTE
cardiovascular exercise e.g. walking, cycling, swimming, jogging. However using your toning
belt regularly will give you stronger, firmer, and more toned abs.
C
ARING FOR YOUR CONTROLLER
Your controller should not be allowed to get wet or be left in excessive sunlight. It may be
cleaned regularly using a soft cloth, lightly dampened in soapy water. Do not allow the interior
of your controller to become wet. Do not use detergents, alcohol, spray aerosols or strong
solvents on your controller.
Access to the interior of the controller is not required for maintenance purposes.
If your controller is damaged, you should not use it but should return it to
local distributor for replacement or repair. Repairs, service and modifications may not be carried
out by anyone other than qualified service personnel authorised by
?
3-pad design ensures that all of the abdominal
Step 2
Step 3
The nerves, in turn, cause
your muscles to contract
and relax rhythmically.
SLENDERTONE
SLENDERTONE .
or your
15
Publicité
Table des Matières
