Publicité
Les langues disponibles
Les langues disponibles
Cutout – Foam Tape Placement". Leave 1/4" (6.35mm) gap
between the foam tape and the edge of the cutout.
Cutout
Figure 4: Counter Cutout – Foam Tape Placement
Install the Cooktop
Insert cooktop into the cutout. Attach clamps of the hold-
down brackets packaged with the cooktop to the rough-in
box. Use the washer and screws provided.
Rough-in Box
Clamp
Adjusting
Screw
Figure 5: Attaching Hold-Down Brackets
Adjust hold-down brackets to desired position and tighten
screws to rough-in box. Insert adjusting screw into clamp
and secure cooktop to countertop.
NOTE:
For solid surface material installations: Insert a wooden
block between the end of the screw and the bottom of the
countertop. Do not overtighten adjusting screw. Trim
excess aluminum tape around cooktop flange.
1/4"
(6.35mm)
Foam
Tape
Foam
Tape
Wooden Block
(to be used with
(Seal)
solid surfacing
material, i.e.
Surell™ and
Corian®)
Adjusting
Clamp
Screw
Connect Gas Supply
The gas inlet to the unit is located at the right rear of rough-
in box.
Opening for Gas
Connection and
Electrical Cord
1"
Install the pressure regulator (supplied with unit) to
manifold pipe using Teflon tape on threads of manifold
pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1
turn for alignment. To prevent possible damage to the gas
pressure regulator, install it after the rough-in box is in its
permanent position. When the regulator is securely
installed on the manifold pipe, the conversion nut will be
easily accessible.
CAUTION:
Do not attempt any adjustment of the pressure
regulator, except conversion to propane.
Connect the gas supply line to the unit pressure regulator
using a 1/2" flex gas line connector between manual shut-
C of Cutout
L
for 30" models: 12 15/16" (313 mm)
for 36" models: 15 15/16" (389 mm)
Figure 6: Rough-in Box Area
Figure 7: Pressure Regulator
English 5
Publicité
