cecotec THERMOSENSE 500 CISNE Manuel D'instructions page 8

- Avoid touching the hot surfaces of the kettle and let it cool
down for a few minutes after use. Grab it by the handle. The
kettle surfaces are likely to be hot during use.
- To prevent possible injury caused by steam, do not face the
spout when operating the kettle.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is earthed.
- Do not immerse the cable, plug, or any other non-removable
part of the appliance in water or any other liquid. Do not
expose the electrical connections to water. Make sure your
hands are dry before handling the plug or switching on the
device.
- Never immerse the appliance in water. Do not touch the
water!
- Check the power cable regularly for visible damage. If the
cable is damaged, it must be repaired by the official Cecotec
Technical Support Service to avoid any type of danger.
- Do not carry or pull the appliance from the power cable. Do
not use the power cable as handle. Do not push the cable
against corners or sharp edges. Do not crush the power
cable with the full weight of the appliance. Keep the cable
away from hot surfaces.
- Do not operate the appliance if its cable, plug, or body show
visible damage, do not operate properly, or have been
dropped.
- Do not use the appliance in confined spaces with explosive
or flammable vapours.
- Do not leave the appliance unattended while in use.
- Unplug it from the power supply when you finish using it and
before leaving the room.
- Do not try to repair the appliance by yourself. Contact the
official Cecotec Technical Support Service.
8
THERMOSENSE 500 CISNE