cecotec THERMOSENSE 500 CISNE Manuel D'instructions page 36

ENGLISH
1. PARTS AND COMPONENTS
1. Pouring spout
Cover
2.
3. Handle
4. Power switch
Indicator light
5.
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Kettle and base
- Instruction manual
3. OPERATION
First use
Before using the kettle for the first time, clean it inside. To do so, follow the steps below:
1. Fill the kettle halfway with water. Do not add any other products.
Next, switch on the kettle using the power switch. The indicator light will light up indicating
2.
that the water is heating up.
3. After boiling the water, the appliance will switch off automatically.
Lift the kettle carefully and empty the water into a sink. Avoid splashing water, as it is hot
4.
and could burn you.
5. The kettle is now ready for use.
36
THERMOSENSE 500 CISNE