Elica PRF0180299 Prescriptions De Montage Et Mode D'emploi page 10

When this warning appears, it means that the installed carbon filter needs to be replaced.
To reset the warning, press and hold key T3 for 3".
In standard mode, the carbon filter warning is not active.
If the hood is used in the filter version, it is necessary to enable the carbon filter warning.
Carbon filter warning activation:
Switch the hood OFF and simultaneously press and hold keys T2 and T3 for 3" (if LED L2 flashes, it means that the
carbon filter is NOT active), press key T3 to activate the carbon filter warning function. LEDs L2 and L5 are steady, wait
10" after which the function is activated followed by an acoustic signal (beep).
Carbon filter warning deactivation:
Switch the hood OFF and simultaneously press and hold keys T2 and T3 for 3" (if LED L2 is steady, it means that the
carbon filter is active), LEDs L2 and L5 are steady, press key T3 and LED L2 will start flashing, wait 10" after which the
carbon filter warning function is deactivated followed by an acoustic signal (beep).
MAINTENANCE WARNINGS
• Cleaning: For cleaning, simply use a cloth moistened with neutral liquid detergents. Do not use cleaning tools or
instruments.
• Avoid the use of abrasive products. DO NOT USE ALCOHOL!
For product maintenance, see the images at the end of the installation marked by this symbol.
• Anti-Grease Filter: The metallic anti-grease filter must be cleaned once a month with non-aggressive detergen-
ts, manually or in a dishwasher on a short wash at low temperatures. To remove the anti-grease filter, pull the spring re-
lease handle.
• The Anti-Grease Filter traps the grease particles produced during cooking. When cleaned in the dishwasher, the metal
grease filter may discolour, but its filtering characteristics remain unchanged.
• Carbon filter (for filter version only): The cartridge must be replaced at least every four months. It CANNOT
be washed or regenerated. As indicated in the drawings section: remove the anti-grease filters, apply a carbon filter on
each side and attach it to the product. Put the anti-grease filters back in place.
• The carbon filter retains any unpleasant odours produced during cooking. • The saturation of the carbon filter can occur
after somewhat prolonged use depending on the type of cooking and how regularly the grease filter is cleaned.
• Washable activated carbon filter (for filter version only):
The carbon filter can be washed every two months (or when indicated by the filter saturation system - if included in your
model). As indicated in the drawing section: remove the grease filter, remove the carbon filter and wash using hot water
and suitable detergents or in a dishwasher at 65°C (if washing in a dishwasher, carry out the complete washing cycle
without dishes inside). Remove any excess water without damaging the filter, then place it in the oven for 10 minutes at
100°C to dry it out completely. Put the anti-grease filters back in place.
Replace the foam layer every 3 years and each time the cloth appears damaged.
• Perimeter suction panel (panel maintenance)
Disassembly:
a. firmly pull the panel (FRONT SIDE) downwards
b. release it from the rear hinges.
Cleaning: the suction panel must be cleaned manually using non-aggressive detergents.
Assembly: the panel must be hooked at the back and secured at the front (with magnets).
Attention! Always check that the panel is securely fixed in place.
Illumination
• Lighting system : The lighting system cannot be replaced by the user, contact Customer Service in case of malfunc-
tion.
• The lighting system is based on LED technology. LEDs provide optimal illumination, last up to 10 times longer than
conventional lamps and save 90% of electricity.
10