Eureka NEC280 Serie Guide Du Propriétaire page 7

How to use cleaner for
cleaning floors
1. Click power button once to start (Fig 1).
Vacuum starts on Mid mode. Use Mode
button to switch between modes.
2. Using motorized floor nozzle, glide back
and forth on area to be cleaned. A void
oversized or sharp items (such as screws)
with cleaner.
3. Twist wrist to engage swivel function.
4. When done, click power button once to
stop motor.
Empty dust cup after every use
1. Press the dust cup release button,
located on the front of the handle just
above the dust cup and pull dust cup
out. (Fig. 2).
2. Press lever to release bottom lid of dust
cup to empty debris. (Fig. 2)
3. To place the dust cup back, angle it
forward so the lower hook catches in
the slot and then gently push it back
towards the wand until you hear click
indicating it is locked in place. (Fig. 3)
How to use hand vacuum
and accessories
CAUTION
!
Moving parts!
Aways turn o hand
vacuum before attaching accessories.
The hand vacuum can be used with or
without tools.
• To use without tools, press release
button and remove wand. Collect
debris directly with hand vacuum
nozzle (Fig. 4).
• To use tools with wand, press release
button to remove motorized floor
nozzle. Slide tool onto end of wand
until it clicks (Fig. 5).
• To use tools with hand vacuum only,
press release button to remove wand.
Slide tool onto hand vacuum until it
clicks.
Mode button
MODE
Power button
2
1. Press
2. Pull out
3. Press
1
Power button
3
2. Push
Crevice tool:
Cleans hard-
to-reach areas
such as corners,
baseboard edges,
dryer vents,
chairs and sofas.
www.eureka.com/ca
Click!
1. Align
5
7