Eureka NEC280 Serie Guide Du Propriétaire page 6

Easy assembly
1.
Slide wand onto hand vacuum
until it clicks (Fig. 1).
2.
Push wand into motorized floor
nozzle until it clicks (Fig. 2).
How to install wall mount
•
Choose location near power outlet.
Locate point high enough on wall
to allow wand and motorized floor
nozzle to hang freely.
•
Place mount against wall and use
pencil to mark drill holes.
•
Drill holes (with 1/4" bit) and insert
drywall anchors. Insert screws
through holes on mount and tighten
until firmly attached(Fig.3).
How to charge battery and
store accessories
•
Place assembled vacuum cleaner
on wall mount.
•
Plug charger into power outlet and
then into charger port on handle(Fig. 4).
•
Loop charger cord into clips on
sides of wall mount.
Battery indicator lights show
level of charge(Fig. 4):
A. Half charged
B. Fully charged
• AB Indicator lights stop blinking when
fully charged.
• Charge battery fully before using for
the first time. This may take up to
six hours.
6
Eureka Customer Service HELPLINE 1-888-365-2230
1
Click!
2
Click!
3
Drywall anchors
4
Cord
clip
B
A