Publicité
Les langues disponibles
Les langues disponibles
EN
Installation
Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water then dry well.
GN Pan Layout
This unit is designed to use standard 1/3 GN
and 1/6 GN pans, or combination of both (not
supplied).
Common pan configuration and support bar usage
(support bars supplied):
Pan layout uses 1 wide support bar
1/3 GN
1/3 GN
1/3 GN
1/3 GN
Pan layout uses 3 support bars
1/6 GN
1/6 GN
1/6 GN
1/6 GN
1/6 GN
1/6 GN
1/6 GN
1/6 GN
4
GL178_ML_A5_v6_20230927.indb 4
GL178_ML_A5_v6_20230927.indb 4
Operation
Control panel
1/3 GN
Note: The appliance is not intended for the
long term storage of food.
1/3 GN
1/3 GN
Adjusting the Temperature
1. Press SET button. The set temperature is
1/3 GN
2. Press up button
1/6 GN
1/6 GN
3. Press SET button to exit.
1/6 GN
1/6 GN
Manual Defrost
1/6 GN
1/6 GN
1. To start manual defrost press defrost button
1/6 GN
1/6 GN
2. To stop manual or automatic defrost press
Refrigerant LED is on. Compressor is
running
Defrost LED is on. Unit is defrosting,
compressor is not running
Up Button
Down Button
Manual defrost button
SET
Set button
I/O
On/off
displayed.
or down button
change set temperature.
and hold for 6 seconds.
defrost button
.
to
2023/9/27 16:55
2023/9/27 16:55
Publicité
