VOLTCRAFT PL-125-T4USB Mode D'emploi page 24

4. Read the license agreement, select if you accept it or not, then press the button NEXT. Note that
if you do not accept it, the installation will not start.
5. To change the installation directory, press the button CHANGE. Then press the button NEXT to
continue.
6. Check the installation overview and then press the button INSTALL to start the installation.
7. The software will be installed in a few minutes. Press the button FINISH to finish the installation.
8. INSERTINg/REPLACINg THE BATTERIES
1. Unscrew the screw on the battery compartment cover using a Phillips screwdriver and take off the
cover of the battery compartment.
2. Insert three AAA batteries, observing the correct polarity. Take note of the labelling on the inside
of the battery compartment.
3. Close the battery compartment.
Replace the batteries when the battery icon appears on the display.
9. oPERATIoN
• do not measure the temperature of live parts or leads, as touching them might
cause a potentially lethal electric shock. Also, the thermometer and sensor
could be damaged.
The sensor included with delivery can only be used for measurements in dry
•
environments and on surfaces with a temperature of >-20 ºC and <+250 ºC. It
is not suitable for use in humid environments or to measure the temperature
of fluids.
The accuracy is only assured when the thermometer is operated at a
•
temperature range of +18 ºC to +28 ºC (excluding the temperature sensor).
The thermometer (excluding the temperature sensor) must not be used outside
•
the operating temperature range. Please note the specifications on operating
temperature in the Technical data section.
• you can utilize the entire measurement range of the thermometer with
optionally available temperature sensors.
23