Ryobi P501G Manuel D'utilisation page 7

 Depress the spindle lock button, then replace the blade
screw. Tighten the blade screw securely by turning it
counterclockwise.
 Return the blade wrench to the storage area.
NOTE: Never use a blade that is too thick to allow the outer
blade washer to engage with the flats on the spindle.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
 Cutting all types of wood products (lumber, plywood,
paneling)
 Cross Cutting/Rip Cutting
 Bevel Cutting
 Pocket Cutting
NOTE: The use of abrasive cut-off wheels is not recom-
mended for this saw.
ASSEMBLY
REMOVING THE BLADE
See Figure 2, page 12.
 Remove the battery pack.
 Remove the blade wrench from the storage area.
 Position the saw as shown. Depress the spindle lock but-
ton, and remove the blade screw by turning it clockwise.
 Remove the outer blade washer.
 Remove the blade.
OPERATION
INSTALLING/REMOVING THE BATTERY
PACK
See Figure 3, page 12.
 Place the battery pack in the saw. Align the raised rib
on the battery pack with the groove inside the saw, then
slide the battery pack into the saw.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
saw before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked when not in use or
carrying at your side.
KICKBACK
See Figures 4 - 7, pages 12 - 13.
Kickback occurs when the blade stalls rapidly and the saw
is driven back towards you. Blade stalling is caused by any
action which pinches the blade in the wood.
DANGER:
Release switch immediately if blade binds or saw stalls.
Kickback could cause you to lose control of the saw. Loss
of control can lead to serious injury.
7 — English