Dogtra CUE GEN2 Manuel Du Propriétaire page 16

HOW TO USE CUE:
BATTERY CHARGING
The Dogtra CUE uses a lithium polymer battery. Recharge
the unit if the indicator light is red, the unit does not turn
on, or the system will not stay on when any button is
pressed.
NOTE 1: Only use Dogtra-approved batteries, chargers,
and accessories for your Dogtra e-collars. This will prevent
any damage that can be incurred from attempting to use a
different charger.
NOTE 2: The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the system, be sure to give
it a full 2-hour initial charge before the first use away from
any flammable substances.
28
Plugs are not included.
Use the 1A plug for your 5V.
NOTE 3: When a charger is not in use, disconnect it from
the power source. Fully charge the batteries if the unit is to
be stored without use for a period of 3 months or more.
Follow the steps below to charge your system:
1. Open the rubber plug on the battery charging receptacle
and plug in the charging cable.
2. Plug the charger into a 120-volt wall outlet or, if using
the auto charger, plug into a cigarette lighter only for
lithium polymer batteries (use a 220 volt European charger
for Europe). All indicator lights should glow red when
properly plugged in and the unit will automatically shut
off during the charging process. You will need to turn the
unit on again before use once the unit is fully charged and
unplugged from the battery cable.
3. The lithium polymer battery is fully charged within 2
hours. The lights will stay red during the charging process
and turn green once the unit is fully charged.
4. After charging, cover the battery charging receptacle
with the rubber plug.
Recharging is required when:
- The LED on the receiver is red
- The LED on the receiver is not illuminated
- Only one battery status bar remains on the Transmitter
LCD screen
- 'Lo' appears on the transmitter LCD screen
- The transmitter or receiver does not work when the button
is pressed in continuous stimulation mode
29