Dogtra CUE GEN2 Manuel Du Propriétaire page 12

8. MULTI DOG DEVICE SELECTION
If you purchase additional receivers, you can select the dog
that you want to give stimulation using 'Dog Select' button.
You can check the selected dog on the LCD screen, and the
transmitter remembers the level set for each receiver.
NOTE You can select the device to be either 2-Dog
system or 3-Dog system
1. Hold 'Dog Select' button for 5 seconds
2. Use the 'Stimulation Level' buttons to determine
2-Dog or 3-Dog system
3. Click 'Dog Select' button again to finish the set up.
PATENTED DESIGN
20
or or
9. HOW TO ADD ADDITIONAL RECEIVER DEVICES
1. Turn the transmitter on, and set it to following:
C (Continuous) mode, stimulation level at 0.
2. Turn off the receiver you want to pair, and hold its power
button for 6 seconds until the LED starts flashing.
3. Press the Base Stimulation Button on the transmitter to
complete the pairing. The receiver's LED should stay on
for 1 second.
Restart the pairing steps if the LED on the receiver
stays on or flashing for more than 1 second. The
pairing between the devices has timed out or failed.
flicker flicker
21